Toro 31526, Installation Instructions Manual

Page: 13 / 20

4. Secure the red wire labeled BYPASS ENGAGE
SWITCH 2 to the override switch center terminal
number 2 (
Figure 22 and Figure 23 ).
5. Secure the gray wire labeled BYPASS ENGAGE
SWITCH 1 to the override switch rear terminal
number 1 (
Figure 22 and Figure 23 ).
Important:
Incorrect switch wiring can
result in damage to the hydraulic system.
Verify that the wiring is installed correctly;
refer to
Testing the Flow-Divider Manifold
(page 16) .
g273521
Figure 23
1. Spring-loaded to the rear
of the switch 5. Front terminal
2. Toggle switch 6. Center terminal
3. Gray wire
7. Rear terminal
4. Red wire
6. Route the toggle switch with the connected
wire harness into the rear of the center console
(
Figure 24 ).
g035968
Figure 24
1. Toggle switch 2. Rear of center console
7. Pull the toggle switch/wire harness through the
center console up to the drilled hole (
Figure 25 ).
g212799
Figure 25
1. Rear of center console 2. Toggle switch
8. Install the toggle switch into the 13 mm (1/2
inch) hole from the bottom of the console; refer
to
Figure 26 for the correct hex locknut and
washer orientation.
Note:
Install the switch spring-loaded toward
the rear of the machine.
13