Toro 315000001, Operator'S Manual

Page: 25 / 32

Figure 49
1. Hose conduit 3. Hose clamp
2. Straight-barbed fitting
(tank rinse pump) 4. Hose 1.9 x 114 cm (3/4 x
45 inch)
3. Slip the hose conduit over the hose leaving about 30
cm (1 ft) of the free end of the hose exposed (
Figure
49 and Figure 50 ).
Figure 50
1. Hose conduit 3. Hose clamp
2. Hose 1.9 x 114 cm (3/4 x
45 inch) 4. 90° barbed fitting
4. Assemble the free end of the hose onto the 90° barbed
fitting at the bottom of the rinse tank (
Figure 50 ).
5. Secure the hose to the fitting with a hose clamp and
finish wrapping the end of the hose with the hose
conduit (
Figure 50 ).
15
Installing Decals
Parts needed for this procedure:
1 Decal (120-0673)
1 Decal (120–0687)
Procedure
1. Thoroughly clean the surface of the 4-way valve bracket
and ball valve bracket (
Figure 51 and Figure 52 ).
Figure 51
1. Decal 120–0673 2. 4-way valve bracket
Figure 52
1. Ball valve bracket 2. Decal 120-0687
2. Peel the backing from the decal and install the decals to
the machine as shown in
Figure 51 and Figure 52 ).
25