Storage
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine. Clean dirt and chaff from the outside of the
engine’s cylinder head fins and blower housing.
Important:
You can wash the machine with
mild detergent and water. Do not pressure wash
the machine. Avoid excessive use of water,
especially near the shift lever plate, and engine.
3. Check the brake; refer to Servicing the Brake in
4. Service the air cleaner; refer to Servicing the Air
Cleaner.
5. Grease the machine; refer to Greasing and
Lubrication in Lubrication , page 26.
6. Change the crankcase oil; refer to Servicing the
Engine in.
7. Check the tire pressure; refer to Checking the Tire
Pressure in Drive System Maintenance , page 33.
8. For long-term storage:
A. Add stabilizer/conditioner additive to fuel in the
tank.
B. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
C. Stop engine, allow to cool and drain the fuel
tank; refer to Servicing the Fuel Tank in Fuel
System Maintenance , page 31, or operate engine
until it stops.
D. Restart engine and run until it stops. Repeat, on
Choke until engine will not restart.
E. Dispose of fuel properly. Recycle as per local
codes.
Note:
Do not store stabilizer/conditioned
gasoline over 90 days.
9. Remove the spark plug(s) and check its condition;
refer to Servicing the Spark Plug. With the
spark plug(s) removed from the engine, pour
two tablespoons of engine oil into the spark plug
hole. Now use the starter to crank the engine and
distribute the oil inside the cylinder. Install the spark
plug(s). Do not install the wire on the spark plug(s).
10. Check and tighten all bolts, nuts, and screws. Repair
or replace any part that is damaged or defective.
11. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
12. Store the machine in a clean, dry garage or storage
area. Remove the key from the ignition switch and
keep it in a memorable place. Cover the machine to
protect it and keep it clean.
48
Summary of Contents for 30984
