2. Remove the latch pin, slide the caster from the
support, and change the spacers (Figure 21).
3. Install the caster in the support and insert the latch
pin (Figure 21).
Adjusting the Handle Height
The handle position can be adjusted to match the
operator’s height preference.
1. Remove the hairpin cotter pins and clevis pins from
the drive levers and neutral locks (Figure 22).
Figure 22
1.
Control rod
5.
Left handle shown
2.
Clevis pin
6.
Neutral lock
3.
Drive lever
7.
Hairpin cotter pin
4.
Operator Presence
Control lever (OPC)
2. Loosen the upper flange bolts (3/8 x 1-1/4 inch)
and flange nut securing handle to rear frame
(Figure 23).
3. Remove the lower flange bolts (3/8 x 1 inch)
and flange nuts securing handle to rear frame
(Figure 23).
4. Pivot handle to desired operating position and
install lower flange bolts (3/8 x 1 inch)and flange
nuts into mounting holes. Tighten all flange bolts.
Figure 23
1.
Control rod fitting
7.
Lower position
2.
Lower mounting holes
8.
Upper mounting hole
3.
Rear frame
9.
Handle
4.
Lower flange bolt (3/8 x 1
inch)
10.
Flange nut (3/8 inch)
5.
Upper flange bolt (3/8 x
1-1/4 inches)
11.
6.
High position
5. Adjust the control rod length by rotating the control
rod in the rod fitting (Figure 23).
6. Install hairpin cotter between drive levers and
neutral locks and into clevis pins (Figure 22).
Note:
Make sure the clevis pins are inserted into
the neutral locks.
7. Perform the hydraulic linkage adjustments when the
handle height is changed; refer Hydraulic Linkage
Adjustments.
24
Summary of Contents for 30984
