Lubrication
Use Figure 24 for locating the grease points on the machine.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
How to Grease
1.
Disengage the PTO and set the parking brake.
2.
Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3.
Clean the grease fittings with a rag. Make sure to scrape
any paint off the front of the fitting(s).
4.
Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of the
bearings.
5.
Wipe up any excess grease.
Lubricating the Caster and
Wheel Bearings
Service Interval:
Before each use or daily—Grease the caster
wheels and caster pivot.
Lubricate the front wheel bearings and front spindles
(Figure 24).
Greasing the Mower Belt Idler
Service Interval:
Every 50 hours—Grease the mower belt
idler.
Grease the fitting on the mower belt idler arm pivot
(Figure 24).
Note:
Remove the mower deck cover to access the grease
fitting for the mower belt idler arm.
Greasing the Pump Control
and Bell Crank
Service Interval:
Every 50 hours—Grease the pump drive
idler pivot.
Every 50 hours—Grease the pump control.
Every 100 hours—Grease the blade engagement
bellcrank.
Every 400 hours—Lubricate cam lock with
Never-Seez®.
Grease the fitting on the pump drive idler pivot and the
pump control.
Grease the blade engagement (PTO) bellcrank (Figure 24).
Figure 24
48 inch Mower Deck Shown
1.
Pump drive idler arm
4.
Mower belt idler arm
2.
Pump control arm
5.
Caster wheel bearing
3.
Bellcrank
6.
Caster pivot
24
Summary of Contents for 30934
Page 49: ...Schematics Electrical Schematic Rev Hydraulic Schematic Rev 49 ...
Page 50: ...Notes 50 ...
Page 51: ...Notes 51 ...
