Toro 30669, Installation Instructions Manual

Page: 11 / 20

Installing the Sunshade
Groundsmaster 3500, 3505, 4000,
and 4100 Machines or Reelmaster
3100, 3555, and 3575 Machines
1. When you install the Universal Sunshade
on a
Reelmaster 3100 traction unit or a
Groundsmaster 3500/3505 traction unit ,
install the Wheel Weight Kit.
2. For Reelmaster 3555 and 3575 traction units ,
skip to step 10 . For all other models, with the
roll bar in the raised position, remove the hairpin
cotters and the 2 pins (
Figure 25 ).
g020023
Figure 25
1. Pin 3. Hairpin cotter
2. Roll bar
3. Insert a washer (13/16 x 1-1/2 inches) onto each
bolt (3/4 x 4 inches) as shown in
Figure 26 .
g020024
Figure 26
1. Nut (3/4 inch) 3. Washer (13/16 x 1-1/2
inches)
2. Roll bar 4. Bolt (3/4 x 4 inches)
4. In the holes where the pins were removed,
install the bolts and washers (
Figure 26 ).
5. Install another washer onto each bolt and secure
with nut (3/4 inch) as shown in (
Figure 26 ).
Torque the nuts 323 to 396 N∙m (238 to 292
ft-lb).
6. Torque the ROPS pivot bolt ( Figure 26 ) 91 to
113 N∙m (67 to 83 ft-lb) to avoid any bouncing of
the roll bar and sunshade.
11