Front Axle
23 x
10.5 - 12
BKT turf
pattern
0.7 bar (10
psi)
1.4 bar (20
psi)
1.7 bar (25
psi)
Rear Axle
18 x 9.5 -
8 BKT turf
pattern
0.7 bar (10
psi)
1.4 bar (20
psi)
1.7 bar (25
psi)
Checking the Torque of the
Wheel Nuts
Service Interval:
Before each use or daily
Torque the wheel nuts to 200 N∙m (148 ft-lb) for the
front axle, and 54 N∙m (40 ft-lb) for the rear axle.
WARNING
Failure to maintain proper torque of the wheel
nuts could result in personal injury.
Ensure that the wheel nuts are torqued
properly.
Using the Operator Platform
Latching Mechanism
Do not operate the mower without first checking that
the operator platform latching mechanism is fully
engaged and in good working order.
WARNING
Operating the machine when the operator
platform latching mechanism is not fully
engaged or is malfunctioning could lead to
serious injury.
Never operate the machine without first
checking that the operator platform latching
mechanism is fully engaged and in good
working order.
Releasing the Platform
1.
Move the locking latch handle towards the front
of the mower until the latch hooks clear the
locking bar.
2.
Raise the platform. The gas spring will provide
assistance.
Securing the Platform
1.
Lower the platform carefully.
Note:
The gas spring will provide assistance.
2.
Move the locking latch handle toward the front
of the mower as the platform nears the fully
lowered position.
Note:
This ensures that the latch hooks clear
the locking bar.
3.
Fully lower the platform and move the locking
handle toward the rear of the mower until the
latch hooks fully engage the locking bar.
g014422
Figure 28
Understanding the
Operator Presence
Controls
Note:
The engine shuts off if you leave the seat
without engaging the parking brake.
Engine Start Lockout:
You can start the engine
only when the forward/reverse travel pedal is in the
N
EUTRAL
position, the cutting unit drive switch is in the
O
FF
position, and the parking brake is engaged.
Engine Run Interlock:
Once you start the engine,
you must be seated before you disengage the parking
brake for the engine to continue to run.
Cutting Unit Drive Lockout:
The drive to the cutting
units is only possible when you are seated. If you rise
from the seat for a period of more than 1 second, a
switch is activated and the drive to the cutting units is
automatically disengaged. To engage the drive to the
cutting units, you must return to the seat, then operate
the cutting unit drive switch to the O
FF
position before
moving it back to the O
N
position. If you rise off the
seat for a moment during normal work, drive to the
cutting units is not affected.
23
Summary of Contents for 30654
Page 36: ...Service Interval Chart g025069 Figure 40 36 ...
Page 57: ...Notes ...
Page 58: ...Notes ...
