Toro 30609, Operator'S Manual

Page: 57 / 84

Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours—Lubricate all of the
bearings and bushings.
Every 500 hours/Yearly (whichever comes first)
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease. Also,
lubricate the machine immediately after every
washing.
The grease-fitting locations and quantities are:
Traction Unit
•
2 front and rear-axle-pivot bushings ( Figure 65 )
•
2 steering-cylinder-ball joints ( Figure 66 )
•
2 tie-rod-ball joints ( Figure 66 )
•
2 king-pin bushings ( Figure 66 ).
The top fitting on the king pin should only be
lubricated annually (2 pumps).
g004687
Figure 65
g011499
Figure 66
Front Mower Deck
•
2 caster-fork-shaft bushings ( Figure 67 )
•
3 spindle-shaft bearings—located under the pulley
(
Figure 68 )
•
2 idler-arm-pivot bushings ( Figure 68 )
g011557
Figure 67
57