Checking the Tire Pressure
Service Interval:
Before each use or daily
DANGER
Low tire pressure decreases machine side-hill
stability. This could cause a rollover, which
may result in personal injury or death.
Do not underinflate the tires.
The correct air pressure in the tires is 172 to 207 kPa
(25 to 30 psi).
Important:
Maintain the recommended pressure
in all tires to ensure a good quality of cut and
proper machine performance. Do not under-inflate
the tires.
Check the air pressure in all the tires before
operating the machine.
g001055
Figure 14
Checking the Torque of the
Wheel-Lug Nuts
Service Interval:
After the first hour
After the first 10 hours
Every 200 hours
Torque the wheel-lug nuts to 115 to 136 N∙m (85 to 100
ft-lb) in the order shown in
and
g033358
Figure 15
Front Wheels
g033359
Figure 16
Rear Wheels
WARNING
Failing to maintain proper torque of the
wheel-lug nuts could result in personal injury.
Torque the wheel-lug nuts to the proper
torque value.
Checking the
Planetary-Gear-Drive Oil
Service Interval:
Every 400 hours (check if you
notice external leakage).
Every 400 hours
Use high quality SAE 85W-140 gear lube as a
replacement.
1.
With machine on level surface, position the
wheel so 1 check plug is at the 12 o'clock
position and the other is at 3 o'clock position
(
).
27
