Figure 40
1.
Red wire
3.
Fuse, 25 amp, blade type
2.
Fuse, 30 amp, blade type
4.
Violet wire
Drive System
Maintenance
Adjusting the Tracking
1. If the machine does not track straight, adjustment
is required.
2. Check the rear tire pressure. Refer to Checking the
Tire Pressure.
3. Loosen the wing nuts on the right control rod and
rotate the turnbuckle in or out to ensure the right
side control lever is centered in the neutral lock
position. Secure the turnbuckle in position with the
wing nuts (Figure 41).
4. Loosen the wing nuts on the left control rod and
rotate the turnbuckle in or out to change the tracking.
Secure the turnbuckle in position with the wing nuts
(Figure 41).
5. Check for proper tracking. Adjust the left control
rod if a change is needed.
Figure 41
1.
Turnbuckle
3.
Top wing nut (left hand
threaded)
2.
Bottom wing nut
Checking the Tire Pressure
Service Interval:
Every 50 hours/Monthly (whichever
comes first)
Check the pressure at the valve stem (Figure 42).
33
Summary of Contents for 30484
Page 56: ...Schematics Hydraulic Schematic Rev A 56...
Page 57: ...Electrical Schematic Rev A 57...
Page 58: ...Notes 58...
Page 59: ...Notes 59...
