Toro 30413, Operator'S Manual

Page: 25 / 64

6. Insert the clevis pins and install the hairpin cotters.
7. Rotate tension rod counterclockwise (finger tight)
to put tension on adjustment.
Figure 20
1. Castor pivot arm 3. Clevis pin and hair pin
cotter
2. Axle mounting holes 4. Tension rod
Figure 21
Adjusting the Skids
The skids should be mounted in the lower position
when operating in height of cuts greater than 2-1/2
inches (64 mm) and in the higher position when
operating in height of cuts lower than 2-1/2 inches (64
mm).
Adjust the skids by removing the flange bolt and nuts,
positioning them as desired, and installing the fasteners
(Figure 22).
Figure 22
1. Skid
Adjusting the Cutting Unit Rollers
The cutting unit rollers should be mounted in the lower
position when operating in height of cuts greater than
2-1/2 inches (64 mm) and in the higher position when
operating in height of cuts lower than 2-1/2 inches (64
mm).
1. Remove the bolt and nut securing the gage wheel to
the cutting unit brackets (Figure 23).
Figure 23
1. Gage wheel
2. Align the roller and spacer with the top holes in the
brackets and secure them with the bolt and nut.
Adjusting the Blade
To ensure proper operation of the cutting unit, there
must be 0.38-0.62 inch (10-16 mm) clearance between
the tips of the wing and center cutting unit blades
(Figure 24).
1. Raise cutting unit so blades are visible and block
center deck section so it cannot fall accidentally.
Wing decks must be horizontal to center cutting
unit.
2. Rotate a center and adjoining wing blade so there
blade tips are aligned. Measure distance between
blade tips, distance should be approximately
0.38-0.62 inch (10-16 mm) (Figure 24).
25