![background image](http://html1.mh-extra.com/html/toro/30326/30326_operators-manual_1133845025.webp)
25
1
2
3
4
8
7
5
6
m–6403
Figure 26
1.
Upper handle
2.
Rear frame
3.
Flange nut, 3/8 inch
4.
Flange bolt, 3/8 x 1 inch
5.
Upper mounting hole
6.
Lower mounting holes
7.
Low position
8.
High position
3. Remove the lower flange bolts (3/8 x 1 inch) and flange
nuts securing handle to rear frame (Fig. 26).
4. Pivot handle to desired operating position and install
lower flange bolts (3/8 x 1 inch) and flange nuts into
mounting holes. Tighten all flange bolts.
5. Thread rod fitting up or down on rod until proper
position is attained and install into fitting to idler
bracket with clevis pin, washer and hairpin cotter. Refer
to Installing the Control Rods, page 16.
6. Check the parking brake adjustment. Refer to Checking
the Brakes, page 32.