Toro 30250TE, Operator'S Manual

Page: 31 / 44

31
1/8 in. (3 mm), the blade is bent and must be replaced.
Refer to Removing the Blades, and Installing the
Blades on page 31.
A blade that is bent or damaged could break
apart and could seriously injure or kill you or
bystanders.
•
Always replace bent or damaged blade with a
new blade.
•
Never file or create sharp notches in the edges
or surfaces of blade.
Warning
Removing the Blades
Blades must be replaced if a solid object is hit, if the blade
is out of balance or is bent. To ensure optimum
performance and continued safety conformance of the
machine, use genuine TORO replacement blades.
Replacement blades made by other manufacturers may
result in non-conformance with safety standards.
1.
Hold the blade end using a rag or thickly-padded
glove. Remove the blade bolt, blade stiffener and
blade from the spindle shaft (Fig. 40).
1
3
2
4
5
m–5227
Figure 40
1. Sail Area of Blade
2. Blade
3. Blade spindle
4. Blade Bolt
5. Blade stiffener
Sharpening the Blades
1. Use a file to sharpen the cutting edge at both ends of
the blade (Fig. 41). Maintain the original angle. The
blade retains its balance if the same amount of
material is removed from both cutting edges.
1
m–1854
Figure 41
1. Sharpen at original angle
2. Check the balance of the blade by putting it on a blade
balancer (Fig. 42). If the blade stays in a horizontal
position, the blade is balanced and can be used. If the
blade is not balanced, file some metal off the end of
the sail area only
(Fig. 40).
Repeat this procedure
until the blade is balanced.
1
2
m–1855
Figure 42
1. Blade 2. Balancer
Installing the Blades
1. Install the blade onto the spindle shaft
(Fig. 40).
Important The sail part of the blade must be pointing
upward, toward the inside of the mower to ensure proper
cutting
(Fig. 40).
2. Install the lock washer and blade bolt
(Fig. 40).
Torque the blade bolt to 85–110 ft-lb (115–140 N m).
Correcting Cutting Unit
Mismatch
If one deck blade cuts lower than the other, correct as
follows.
Note:
Tire air pressure is critical in these procedures.
Make sure all tires have correct pressure.
1. Stop the engine, remove the key and disconnect the
spark plug wire(s) from the spark plug(s).
2. Adjust the tire pressure in all tires to specifications on
page 27.
3. Check that the blades and spindle shafts are not bent.
Refer to Checking for Bent Blades on page 30.
4. Set the height-of-cut to the 4 in. (101.6 mm) position.
Refer to Adjusting the Height-Of-Cut in the Operation
section.