13
Assembly
Note: Determine the left and right sides of the machine
from the normal operating position.
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
QTY.
USE
Fuel tank
Control panel
Bolt, 5/16 x 7/8 in.
Lock washer, 5/16 in.
Washer, 5/16
Spring
Stud
Hose clamp
1
1
2
2
4
2
2
1
Install control panel and fuel tank
Upper handle
Flanged bolt 3/8 x 1 in. (26 mm)
Flange nut 3/8 in.
1
4
4
Install upper handle to frame
Clevis pin
Washer
Hairpin cotter pin
1
1
2
Install control rods
Hairpin cotter pin
2
Install hairpin cotter pins
Operator’s Manual
Engine Operator’s Manual
Parts Catalog
Registration card
1
1
1
1
Read before operating machine
Read before operating machine
Fill out and return to Toro
Installing the Control Panel
and Fuel Tank
Note: Hardware to install control panel and fuel tank is
installed in the bottom of fuel tank.
1. Remove the bolts and nuts holding the control panel to
the rear frame. Discard these nuts and bolts.
2. Slide the control panel over the shift lever and under
the bottom of the rear frame (Fig. 2).
m–5221
3
1
2
Figure 2
1.
Rear frame
2.
Control panel
3.
Fuel tank
3. Align fuel tank with the top of the rear frame (Fig. 2).
4. Place the transmission in neutral.
