Toro 29645, Operator'S Manual

Page: 5 / 20

Setup
Important:
Remove and discard the protective plastic
sheet that covers the engine.
1
Attaching the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the machine housing
(
Figure 3 ).
Important:
Route the cables to the outside of the
handle as you install the handle.
Figure 3
1. Handle knobs 2. Upper handle knob
2. Align the holes in the ends of the handle with those
in the machine housing, and loosely screw the handle
knobs back in.
3. Move the handle to the operating position ( Figure 3 ),
and tighten the 2 handle knobs as tightly as you can.
4. Loosen the upper handle knob, move the upper handle
to the operating position (
Figure 3 ), and tighten the
upper handle knob.
2
Installing the Recoil-Starter
Rope in the Rope Guide
No Parts Required
Procedure
Important:
To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(
Figure 4 ).
Figure 4
1. Recoil-starter rope 2. Rope guide
3
Filling the Engine with Oil
No Parts Required
Procedure
Important:
Your machine does not come with oil in
the engine. Before starting the engine, fill the engine
with oil.
1. Move the machine to a level surface.
5