WARNING
The engine must be running and the drive
wheels must be turning so motion control
adjustment can be performed. Contact
with moving parts or hot surfaces may
cause personal injury.
Keep your fingers, hands, and clothing
clear of rotating components and hot
surfaces.
7.
With the engine running, slowly move the
directional control in both forward and reverse
directions (5 to 6 times). Check the oil level, and
add oil as required after shutting off the engine.
It may be necessary to repeat step
until all air
is purged from the system. Air is purged from
the transaxle when it operates at normal sound
levels and moves forward and reverse smoothly
at normal speeds.
8.
Shut off the engine, remove the key, engage
the parking brake, and wait for all moving part
to stop.
9.
Remove the jack stands and lower the rear of
machine.
10.
Reset the transmission-oil maintenance
reminder; refer to
Resetting the Transmission-Oil
Maintenance Reminder (page 46)
.
Resetting the Transmission-Oil
Maintenance Reminder
1.
Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 30)
.
Note:
You must engage the parking brake to
reset the maintenance reminder.
2.
Cycle the key switch between the
RUN
position
and the
OFF
position 6 times within 8 seconds.
The Service Transmission screen displays and
flashes (
).
g212118
Figure 57
Service Transmission Screen
3.
Press down the multi-function switch.
The transmission-oil maintenance reminder
resets to 250 (hours), exits the service
transmission screen, and returns to the default
screen.
Note:
You can exit the service transmission screen
at any time by turning the key to either the OFF or
the START positions.
46
