! !"!
&,645+0) *'+)*51(%65 .'7'34 %16.& $3+0)
*#0&4 +051 %105#%5 8+5* /17+0) $.#&'
105#%5 8+5* $.#&' %16.& %#64' 4'3+164 2'3:
410#. +0,639
1 015 #&,645 5*' *'+)*51(%65 4'55+0)4
8*'0 '0)+0' +4 3600+0) #0& $.#&' +4 315#5+0)
1 015 265 (+0)'34 60&'3 *164+0) 51 .+(5 /18:
'3 8*'0 #&,645+0) *'+)*51(%65 .'7'34
For easier adjustment, lift housing up so wheel is
off ground.
1 015 2.#%' *#0&4 60&'3 &'%- 51 .+(5
*164+0)
Squeeze adjusting lever toward wheel and
move to desired setting (Fig. 14). Ensure pin on
adjusting lever engages notch in housing. Adjust all
wheels to the same setting.
15'
Front wheels can be adjusted to 13 mm (1/2").
Move adjusting lever past 1" and release pin into
notch in housing.
In conditions when maximum power is required or
when cutting in spongy thatch that causes rear
wheels to sink in turf, raise rear wheel setting one
increment higher. Make sure wheel settings are
returned to equal settings, when cutting in normal
conditions, to achieve the best quality of cut.
+)63'
'+)*5:1(:%65 .'7'3
146
1
♦
2
♦
3
=
=
=
=
=
25 mm (1
″
)
38 mm
51 mm
64 mm
76 mm
(1-1/2
(2
(2-1/2
(3
″
)
″
)
″
)
″
)
! !
Check the control bar before each use to ensure the
Blade Brake Clutch (BBC) system is operating
properly.
13/#. 10531. #3 2'3#5+10 !'45
With engine off, wheel mower onto a paved
surface in a nonĆwindy area.
Put all four wheels in 3" height-of-cut position
(Fig. 14).
Put ground speed selector in
(neutral) position.
Take a half sheet of newspaper and crumple it into
a ball small enough to go under deck (approx. three
inches in diameter) (Fig. 15).
Place ball of newspaper five inches in front of
mower (Fig. 15).
+)63'
756
%/
Start the engine.
Push control bar down to lowest position (Fig. 16).
+)63'
Lift control bar to the normal blade engaged"
position (about one inch below the handle)
(Position A, Fig. 17). The fan" noise indicates that
the mower blade is turning.
