Toro 25497, Installation Instructions Manual

Page: 1 / 8

Form No. 3398-100 Rev A
Tilt Steering Kit
RT1200 Traction Unit
Model No. 25497
Model No. 25497E
Installation Instructions
Installation
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
1
Preparing to Install the
Tilt-Steering Column
No Parts Required
Procedure
1. Move the machine to a level surface.
Note:
Ensure that the front wheels of the machine
are straight.
2. Set the parking brake, shut off the engine, and remove
the key from the key switch.
3. Remove the right panel; refer to the Operator’s Manual .
4. Rotate the battery-disconnect switch to the O
FF
position; refer to the Operator’s Manual .
2
Removing the Steering Wheel
No Parts Required
Procedure
1. Pry the cover out from the hub of the steering wheel
(
Figure 1 ).
Figure 1
1. Cover 3. Steering wheel
2. Nut (13/16 inch) 4. Fixed-steering column
2. Remove the nut (13/16 inch) that secures the steering
wheel to the fixed-steering column (
Figure 1 ).
3. Remove the steering wheel by pulling it away from the
column (
Figure 1 ).
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3398-100* A