Toro 23825, Operator'S Manual

Page: 77 / 128

Positioning the Cab (Model
with Cab only)
Positioning the Cab for Drilling
Operation
1. Push back on the swing rocker switch (until the cab
stops) to swing the cab to the drill position (
Figure 93 ).
Figure 93
1. Swing rocker switch 2. Rotate rocker switch
Important:
Ensure that you swing the cab out
completely before rotating, or you may contact the
machine, causing damage to the cab.
2. Push back on the rotate rocker switch to rotate the cab
to the desired drill position (
Figure 93 ).
Positioning the Cab into Transport
Mode
1. Push forward on the rotate rocker switch (until the
cab stops) to rotate the cab to the transport position
(
Figure 93 ).
Important:
Ensure that you completely rotate the
cab to the transport position (clockwise) before
swining, or you may contact the machine, causing
damage to the cab.
2. Push forward on the swing rocker switch (until the
cab stops) to swing the cab to the transport position
(
Figure 93 ).
Opening the Door (Model with
Cab only)
Open the door from the outside by pulling on the handle, and
swing the door to the left (
Figure 94 ).
Figure 94
1. Door handle
Open the door from the inside by pulling the knob backward
and pushing the door to the outside (
Figure 95 ).
Figure 95
1. Door knob
77