Engine Key Switch
The key switch has 3 positions as follows (
1
2
3
G0221 15
Figure 45
1.
Engine-off position
3.
Engine-start position
2.
Engine-run position
•
Engine-off position—turn the key to this position to stop
the engine. You cannot start the engine from the operator
platform when the key is in this position.
•
Engine-run position—turn the key to this position after
starting the engine. Turning the key to this position
also enables the engine start button from the operator
platform.
•
Engine-start position—turn the key to this position to
start the engine. Release the key to the Run position once
the engine has started.
Fluid-pump Switch
Use this switch to turn on the fluid pump to use the spray gun
when cleaning the machine (
Drill-pendant Receptacle
Plug the drill pendant into this receptacle to attach it to the
machine (
).
Drive-pendant Receptacle
Plug the drive pendant into this receptacle to attach it to the
machine (
).
Drill Frame and Stabilizer Controls
Figure 46
1.
Drill-frame tilt lever
3.
Right-stabilizer lever
2.
Left-stabilizer lever
Stabilizer Levers
Use the stabilizer levers to raise and lower the stabilizers.
Note:
The Drive/Drill switch on the operator panel must be
switched to the Drive position for this function to work.
Drill-frame Tilt Lever
Use the drill-frame tilt lever to tilt the drill frame to place
the stake-down plate on the ground or to return the frame
to the travel position.
Note:
The Drive/Drill switch on the operator panel must be
switched to the Drive position for this function to work.
42