Toro 23825, Operator'S Manual

Page: 36 / 128

Control Panel
g021834
1
2
3
4
5
6
7
8
9
10
Figure 38
1. Engine-stop button 6. Ground-strike-reset switch
2. Exit-side lockout—reset
light 7. Exit-side-lockout—reset
switch
3. Exit-side
lockout—drill-enabled
light 8. Drive/drill switch
4. Receiver-battery-status
light 9. Lights switch
5. Engine-start button 10. Engine-speed switch
Exit-side Lockout—Reset Light
This light ( Figure 38 ) illuminates yellow when the exit-side
lockout function is turned off on exit-side-lockout transmitter,
indicating that you may reset the system.
Exit-side Lockout—Drill-enabled Light
This light ( Figure 38 ) illuminates green when the
exit-side-lockout feature has been turned off and reset and
the machine is ready to drill.
Exit-side Lockout—Reset Switch
Press this switch ( Figure 38 ) to enable drilling operation when
the reset light illuminates.
Transmitter-battery-status Light
This light ( Figure 38 ) illuminates red when the battery on
the exit-side-lockout transmitter is too low to transmit. Stop
drilling operations and fix the problem with the transmitter
before continuing.
Engine-start Button
Press this button ( Figure 38 ) to start the engine. The key
switch on the rear, control panel must be in the On position.
Engine-stop Button
Press this button ( Figure 38 ) to immediately stop the engine
and all drilling operations. You must pull this button out
before you can start the engine again.
Ground-strike-reset Switch
Press this switch ( Figure 38 ) to reset the Zap-Alert system
after a ground strike has occurred and been fixed; refer to
Deploying the Zap-alert System (page 67) .
Drive/Drill Switch
Press the top of this switch ( Figure 38 ) to enable the drive and
setup controls or the bottom to enable drill and pipe-loader
functions.
Lights Switch
Press the top of this switch ( Figure 38 ) to turn the machine
lights on or the bottom of this switch to turn them off.
Engine-speed Switch
•
Press and hold the top of this switch to increase the
engine speed.
•
Press and hold the bottom of this switch to decrease the
engine speed.
•
Release the switch to maintain the current engine speed.
36