Figure 17
1.
Nut
2.
Shear pin
4.
If the shear pin is damaged, remove the pin and replace
with a Toro recommended pin. Secure the pin with
a nut.
Checking the Broom Segments
1.
Move the machine to a level surface.
2.
Turn off the engine, wait for all moving parts to stop,
and remove the spark plug wire(s).
3.
Raise the broom by resetting the caster positions.
4.
On both sides of the unit, remove and retain the outer
bearing housing hardware.
5.
Manually pull the power unit rearward to remove the
broom assembly from the unit.
6.
Support the splined shaft on either side of the gearbox.
7.
Stand the broom core assembly on end so the
removable end retainer plate is facing upward.
Figure 18
1.
Hardware
4.
Support shaft
2.
End retainer plate
5.
Alignment fingers
3.
Broom segment
8.
Remove and retain the hardware from the end retainer
plate.
9.
Remove the damaged broom segment(s). Install the
new segment(s) by staggering the metal ring alignment
fingers as shown in Figure 18.
Important:
Damage may occur to the broom
assembly if the broom segments are not properly
installed.
10.
Install the broom assembly onto the unit.
Important:
Make sure the bearing setscrews are
tightened before operating the broom.
Adjusting the Traction Cable
If the machine does not drive in the forward or reverse speeds
or it drives when you release the traction lever, adjust the
traction cable.
With the traction lever disengaged, check the pin in the
elongated slot in the left side of the machine above the tire.
There should be a gap of 6 mm (1/4 inch) from the front of
the slot to the front edge of the pin ( Checking the Traction
Cable (page 16)).
If the left hand traction cable is not properly adjusted, do
the following steps:
1.
Loosen the jam nut.
2.
Loosen or tighten the turnbuckle to adjust the pin until
it is the proper gap from the front edge of the slot.
3.
Tighten the jam nut (Figure 19).
3
g019016
Figure 19
1.
Jam nut
2.
Turnbuckle
Adjusting the Broom Drive
If the broom cable is not properly adjusted (see Checking the
Broom Cable (page 17)), do the following steps:
1.
Loosen the jam nut (Figure 20).
18
Summary of Contents for 23740
Page 23: ...Notes 23...
