Toro 23508, Operator'S Manual

Page: 11 / 35

Hydrostatic-Drive Bypass Lever
The hydrostatic-drive bypass lever ( Figure 8 ) releases
the hydrostatic-drive system so that you can move the
machine by hand without the engine running.
For normal operating position, pull up on the handle
and then push it in until all 3 notches are inside the
frame.
Note:
The last notch on the handle does not latch
on the slot.
To release the drive wheels, pull up on the handle and
pull it out until the last notch engages in the slot. Then
push the handle down.
g021333
Figure 8
1. Handle in—normal operating position
2. All notches inside frame
3. Handle out—hydrostatic-drive release
4. Last notch engaged in slot
Specifications
Note:
Specifications and design are subject to
change without notice.
Width 76 cm (30 inches)
Length (operating) 137 cm (54 inches)
Length (with handle stored) 95.25 cm (37.5 inches)
Height (operating) 113 cm (44.5 inches)
Height (with handle stored) 73.5 cm (29 inches)
Weight 120.2 kg (265 lb)
Torque Requirements
Bolt Location Torque
Engine mounting bolts 37 to 45 N
⋅
m (27 to 33 ft-lb)
Clutch mounting bolts 66 to 83 N ⋅ m (49 to 61 ft-lb)
Slicer shaft nut 88 to 115 N ⋅ m (65 to 85 ft-lb)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
11