4. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the
charger leads from the battery posts (Figure 41).
5. Install the battery onto the machine and connect the
battery cables, refer to Installing the Battery.
Note:
Do not run the machine with the battery
disconnected, electrical damage may occur.
Figure 41
1.
Positive Battery Post
3.
Red (+) Charger Lead
2.
Negative Battery Post
4.
Black (-) Charger Lead
Replacing the Fuses
There are 4 fuses in the electrical system. They are under
the control panel on the left side (Figure 42).
Start Circuit
30 amp
Charge Circuit
25 amp
Cooler fan Circuit
15 amp
Headlight (optional)
15 amp
Figure 42
1.
Fuse block
Drive System
Maintenance
Servicing the Tracks
Cleaning the Tracks
Service Interval:
Before each use or daily
Check the tracks for excessive wear and clean them
periodically. If the tracks are worn, replace them.
1. Lower the grinder.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Using a water hose or pressure washer, remove dirt
from each track system.
Important:
Ensure that you use high-pressure
water to wash only the track area. Do not use
a high-pressure washer to clean the rest of the
machine. High-pressure washing can damage the
electrical system and hydraulic valves or deplete
grease.
Important:
Ensure that you fully clean the road
wheels and the drive sprocket (Figure 43).
Figure 43
1.
Road wheels
3.
Track
2.
Drive sprocket
Checking and Adjusting the Track
Tension
Service Interval:
After the first 50 hours
Every 100 hours
To check the tension of each track, place 45 lb (20.4 kg)
on the track midway between the front road wheel and
30
Summary of Contents for 23210
Page 41: ...Schematics g013418 Electrical Schematic Rev A 41 ...
Page 42: ...g013419 Hydraulic Schematic Rev A 42 ...
Page 43: ...Notes 43 ...