Toro 23210, Operator'S Manual, Page: 23 / 44

Lubrication
Greasing the Machine
Service Interval: Before each use or daily (Grease
immediately after every washing.)
Grease Type: General-purpose grease.
1. Lower the grinder and stop the engine. Remove the
key.
2. Clean the grease fittings with a rag.
3. Connect a grease gun to each fitting (Figure 28 and
Figure 29).
4. Pump grease into the fittings until grease begins to
ooze out of the bearings (approximately 3 pumps).
5. Wipe up any excess grease.
Figure 28
Figure 29
Engine Maintenance
Servicing the Air Cleaner
Service Interval: Every 250 hours
Cleaning the Air Cleaner Body and
Cover
1. Stop the engine and remove the key.
2. Check the air cleaner body for damage which could
cause an air leak. Check the whole intake system
for leaks, damage, or loose hose clamps. Replace or
repair and damaged components.
3. Release the latches on the air cleaner and pull the air
cleaner cover off of the air cleaner body (Figure 30).
Important:
Do not remove the air filters yet.
G01 1475
1 2
3
4
5
Figure 30
1. Air filter body 4. Air cleaner cover
2. Safety filter 5. Dust cap
3. Primary filter
4. Squeeze the dust cap sides to open it and knock the
dust out.
5. Clean the inside of the air cleaner cover with
compressed air.
Replacing the Filters
1. Gently slide the primary filter out of the air cleaner
body (Figure 30). Avoid knocking the filter into the
side of the body.
Important:
Do not attempt to clean the primary
filter.
2. Check the condition of the safety filter without
removing it. If it is dirty or damaged, replace it.
23