Toro 22983, Operator'S Manual

Page: 10 / 52

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Boom (sold separately) 1
1
Chain (sold separately) 1
Install the boom and chain.
2
No parts required
–
Check the fluid levels.
3
No parts required
–
Charge the battery.
1
Installing the Boom and
Chain
Parts needed for this procedure:
1 Boom (sold separately)
1 Chain (sold separately)
Procedure
Important:
There are several boom and chain size
configurations available. Refer to your Authorized
Service Dealer to obtain the appropriate boom and
chain to meet your requirements.
1. Park the machine on a level surface and engage
the parking brake.
2. Shut off the engine and remove the key.
3. Remove the bolt, 2 saddle washers, and nut
securing the spoils auger and remove the auger
(
Figure 4 ).
Note:
Save the fasteners for future use.
g011470
Figure 4
1. Spoils auger 6. Adjusting bolt
2. Boom 7. Jam nut
3. Bolt (2) 8. Arm on the drive head
4. Double washer 9. Drive sprocket
5. Nut (2)
4. Remove the 2 bolts, nuts, and double washers
from the sides of the boom (
Figure 4 ).
5. Loosen the adjusting bolt and jam nut ( Figure 4 ).
6. Slide the boom over the arm on the drive head.
7. Install the 2 bolts, nuts, and double washers
removed in step
4 through the boom and arm,
but do not tighten them.
8. If the chain is not connected, connect the links
by pressing or hammering the clevis pin supplied
with the chain through the links.
Important:
To avoid bending the chain links,
place blocks under and between the links
when hammering the clevis pin through.
9. Secure the clevis pin with the cotter pin supplied
with the chain.
10