Toro 22600HD SGR-6, Operator'S Manual

Page: 16 / 24

6. When the oil has drained completely, install the plug
and wipe up any spilled oil.
Note:
Dispose of the used oil at a certified recycling
center.
7. Remove the oil fill cap and slowly pour approximately
80 percent of the specified amount of oil into the
engine (
Figure 16 ).
8. Slowly add additional oil to bring the oil level to the
upper limit mark on the dipstick. Refer to
Checking the
Engine-Oil Level (page 11) .
9. Install the oil fill cap.
Cleaning the Sediment Cup
Service Interval: Every 100 hours
Yearly or before storage
Underneath the fuel valve is a sediment cup to catch dirt in
the fuel.
1. Move the fuel valve to the O
FF
position, all the way
to the left.
2. Unscrew the sediment cup. Make sure not to misplace
the O-ring (
Figure 17 ).
Figure 17
1. Sediment cup 2. O-ring
3. Clean the reservoir and the O-ring using a cleaning
solvent and dry carefully.
Note:
Make sure not to misplace the O-ring.
4. Put the O-ring in place in the groove of the cup and
replace the sediment cup.
5. Turn the fuel valve to the O
N
position, all the way to
the right, and check for leaks.
Note:
If it leaks, replace the O-ring.
Servicing the Spark Plug
Service Interval: Every 100 hours—Check the spark plugs.
Ensure that the air gap between the center and side electrodes
is correct before installing the spark plug. Use a spark plug
wrench for removing and installing the spark plug and a
gapping tool/feeler gauge to check and adjust the air gap.
Install a new spark plug if necessary.
Type: BPR6ES (NKG) or equivalent
Air Gap: 0.70 to 0.80 mm (0.28 to 0.031 inch)
Removing the Spark Plug
1. Lower the grinder and shut off the machine; Refer to
Shutting Off the Engine (page 12) .
2. Pull the wire off the spark plug ( Figure 18 ).
Figure 18
1. Spark plug 2. Wire
3. Clean around the spark plug.
4. Remove the spark plug and the metal washer.
16