![Toro 22600HD SGR-6 Operator'S Manual Download Page 13](http://html.mh-extra.com/html/toro/22600hd-sgr-6/22600hd-sgr-6_operators-manual_1131610013.webp)
3.
Move the machine to the front of the stump and set
the parking brake.
4.
Move throttle up to the Engage position. The cutting
wheel will begin rotating.
5.
Swing the cutting wheel to one side (
), then
lower it approximately 13 mm to 25 mm (1/2 inch to
1 inch) into the front-top corner of the stump. Swing
the cutting wheel back and forth, lowering the cutting
wheel approximately 13 mm to 25 mm (1/2 inch to 1
inch) before each sweep, until you have removed the
front portion of the stump to ground level (A through
D in
Figure 13
6.
Raise the cutting wheel, release the parking brake, and
move the machine forward a few centimeters (inches).
Set the parking brake.
7.
Repeat steps
and
until you have completely
removed the stump (E through H in
).
8.
Move throttle to the Disengage position, push the
handle down enough to raise the cutting wheel off the
ground. Wait for the cutting wheel to stop rotating
then release the parking brake and pull the machine
away from the stump.
Note:
Do not
let the front of the machine touch the
ground until you are sure the cutting wheel has stopped
turning.
9.
Shut off the engine; refer to
(page 12)
.
13
Summary of Contents for 22600HD SGR-6
Page 22: ...Notes 22 ...
Page 23: ...Notes 23 ...