g268495
Figure 5
1.
Pin
3.
Adjustment shaft
2.
Hairpin cotter
5.
Install the pin and hairpin cotter.
6.
Repeat steps
and
for the other side of the
broom.
Note:
Ensure to adjust both sides evenly to
ensure the bristles across the broom wear
evenly.
7.
Check the sweeping path again; refer to
Checking the Sweeping Path (page 7)
.
Dumping the Broom Bucket
1.
Move the broom to the dumping location.
2.
Raise the loader arms and tilt the broom forward.
3.
Start the broom so that it rotates clockwise when
viewed from the left side.
4.
When the bucket is empty, stop the broom, tilt
the broom rearward, and lower the loader arms.
Clearing a Clogged Broom
WARNING
The rotating broom could cause serious
injury.
Shut off the machine and allow all rotating
parts to stop before cleaning the broom.
1.
Stay in the operating position and release the
traction control.
2.
While engaging the broom, raise the broom
above the ground.
If you cannot unclog the broom by lifting it into the air,
clear the broom as follows:
1.
Park the machine on a level surface and
disengage the auxiliary hydraulics.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
While wearing thickly-padded gloves, use
caution to manually clear foreign objects out of
the broom.
CAUTION
Sharp objects can become entangled in the
bristles and can cause personal injury.
Wear gloves and use caution when cleaning
foreign objects out of the broom; never use
your bare hands.
Transport Position
When transporting an attachment, keep the
attachment as close to the ground as possible, no
more than 15 cm (6 inches) above the ground, and
keep the loader arms retracted. Tilt it rearward.
g267349
Figure 6
1.
No more than 15 cm (6
inches) above the ground
2.
Tilt the attachment
rearward.
8
Summary of Contents for 22543
Page 14: ...Notes...
Page 15: ...Notes...
