Toro 22426, Operator'S Manual

Page: 6 / 20

Starting the Power Rake
1. Start the traction unit engine.
2. Slowly lower the power rake to the ground.
3. Engage the hydraulic-control lever for auxiliary
implements.
4. Move the traction unit forward or backward as
desired.
Note:
For the roller to operate effectively, rotate
it in the opposite direction of the traction-unit
track. The direction of the roller rotation is
controlled by the traction unit hydraulic controls;
refer to
Figure 5 below.
g026004
Figure 5
Setting the Barrier Gap
The normal gap between the roller and the barrier for
average conditions is approximately 3.2 cm (1-1/4
inches).
The barrier gap should be the same all the way across.
Set the barrier gap as follows:
•
To widen the barrier gap, loosen the 2 U-bolts (3/8
inch) that hold the barrier mount (
Figure 6 ).
Note:
A wider opening will allow more dirt and
rock to pass through.
g026012
Figure 6
1. U bolts (3/8 inch)
•
To narrow the barrier gap, tighten the 2 U-bolts
(3/8 inch) that hold the barrier mount (
Figure 6 ).
Important:
Ensure that the roller does not hit the
barrier, as the parts could be damaged.
6