Setup
1
Installing the Valve Lever
Parts needed for this procedure:
1
Speed selector valve lever
Procedure
1. Remove and discard the nut securing the bolt and
lock washer to the speed selector lever.
2. Secure the lever to the speed selector valve using the
bolt and lock washer as illustrated in Figure 4.
Figure 4
1.
Speed selector valve lever
2.
Speed selector valve
2
Checking Fluid Levels
No Parts Required
Procedure
Before starting the engine for the first time, check the
engine oil, hydraulic fluid, and engine coolant levels.
Refer to Operation for more information.
3
Installing the Battery
Parts needed for this procedure:
1
Maintenance-free battery
Procedure
The traction unit is shipped without a battery. Your
dealer will provide a maintenance free battery with the
product.
WARNING
Battery terminals or metal tools could short against
metal components, causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
•
When removing or installing the battery, do not
allow the battery terminals to touch any metal
parts of the traction unit.
•
Do not allow metal tools to short between the
battery terminals and metal parts of the traction
unit.
1. Remove the four bolts securing the battery cover
and remove the cover (Figure 5).
Figure 5
1.
Battery cover
5.
Nut
2.
Bolt
6.
Positive cable
3.
Battery
7.
Negative cable
4.
Bars
2. Remove the nuts and bars which will secure the
battery (Figure 5).
3. Charge the battery for 10 to 15 minutes at 25 to
30 amps or 30 minutes at 4 to 6 amps. Do not
overcharge the battery.
12
Summary of Contents for 22337CP
