Toro 22196, Operator'S Manual

Page: 8 / 32

Figure 3
1. Bag support rod 8. Thin nylon insert locknut
(2)
2. Carriage bolt
9. Bottom hole in housing
3. Bag aligning plate 10. Washer (4)
4. Cap locknuts (3) 11. Locknut (2)
5. Handle
12. Bolt, (5/16 x 1-1/4 inches)
(2)
6. Bolt, (5/16 x 1-1/2 inches)
(2) 13. Cable tie (3)
7. Handle latch (2)
2. Secure the handle latches to the handle with 2 bolts
(5/16 x 1-1/2 inches), washers, and locknuts (5/16
inch) (Figure 3).
Note:
You can adjust the handle height for
comfortable operation. Stand behind the handle to
determine the height. To adjust the handle height,
position the bolts and the locknuts that secure the
handle latches to the handle into the other mounting
holes in the latches.
3. Insert the carriage bolt through the bag aligning
plate and the second hole from the top on the left
side of the handle, and secure it with a cap locknut
(Figure 3).
4. Slide the bag support rod through the third from the
top mounting holes in the handle, and secure each
end with a cap locknut (Figure 3).
5. Use cable ties to secure the control cables to the
handle (Figure 3).
2
Installing the Starter Rope
No Parts Required
Procedure
Pull the starter rope through the rope guide on the
handle (Figure 4).
Figure 4
1. Starter rope 2. Rope guide
Note:
To make the rope easier to install, squeeze the
blade control bar on the handle.
3
Installing the Discharge Tunnel
Plug
Parts needed for this procedure:
1 Discharge tunnel plug
Procedure
1. Open the discharge door by pulling the handle
rearward (Figure 5). Hold the discharge door handle
to prevent the spring-loaded door from closing while
you insert the plug.
8