Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
2
No parts required
–
Fill the crankcase with oil.
3
No parts required
–
Adjust the handle height.
Note:
Determine the left and right sides of the machine
from the normal operating position.
1
Installing the Handle
Parts needed for this procedure:
6
Oval-head bolt
6
Locknut
1
Upper handle
2
Oval-head bolt
2
Locknut
2
Self-tapping hex head screw
2
Washer
2
Spacer (5-0652)
1
Cable tie
Procedure
1. Attach the upper handle to the lower handle using
4 oval-head bolts and 4 locknuts.
Note:
Ensure that the bolt heads are to the
outside
of the handle.
2. Attach the handle to the mower housing with
2 self-tapping hex head screws, 2 washers, and
2 spacers (Figure 3),
but do not tighten the
self-tapping hex head screws.
Note:
Ensure that you insert the spacers between
the mower housing and the handle (Figure 4).
Figure 3
1.
End cap on rear door rod
4.
Handle brace (2)
2.
Self-tapping hex head
screw, washer, and spacer
(2)
5.
Bolt head aligned with the
handle
3.
Locknut (2)
6
