11
3. Set all four wheels in to the E cutting setting (Fig. 15).
4. Put the ground speed selector in the N (Neutral)
position.
5. Take a half sheet of newspaper and crumple it into a
ball small enough to go under the deck (about three
inches [76 mm] in diameter) (Fig. 10).
756
5" (12,5 cm)
Figure 10
6. Place the ball of newspaper five inches in front of the
lawn mower (Fig. 10).
7. Start the engine.
8. Push the control bar down to its lowest position
(Fig. 11).
Figure 11
9.
Lift control bar to the normal blade engaged position
(about one inch below the handle) [Refer to
position A in Fig. 12]). The fan-like noise indicates
that the lawn mower blade is turning.
1” (2,5 cm)
A
B
Figure 12
10.
Release the control bar (Refer to position B in
Fig. 13). You should hear a “bang”. The blade should
stop in three seconds.
A
B
Figure 13
11.
Immediately push the lawn mower over the
newspaper ball.
12.
Turn off the engine and wait for all moving parts to
stop.
13.
Walk around the lawn mower to check for the
newspaper ball. If the ball did not go under the deck,
repeat steps 6 through 12.
Summary of Contents for 20487
Page 26: ...26 141 1 Figure 33 1 Dethatcher attachment ...
Page 27: ...27 ...
