Toro 140-2054, Installation Instructions

Page: 1 / 2

Form No. 3436-462 Rev B
Sunshade Kit
for TimeCutter ® Riding Mowers
Model No. 140-2054
Installation Instructions
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
ARK
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Support the rear of the machine with jack stands
and remove the rear tires.
4. Secure the receiver brackets to the front 2 holes
in the frame using 2 bolts (1/2 inch x 1-1/8
inch) and split lockwashers (
Figure 1 ). If your
machine is not equipped with a ROPS, insert the
spacer plate as shown in
Figure 1 .
Important:
Ensure that you do not pinch
any cables or fuel lines when installing the
receiver bracket.
g309688
Figure 1
1. Bolt (1/2 inch x 1-1/8 inch) 4. Spacer plate (optional)
2. Split lockwasher (1/2 inch) 5. Receiver bracket
3. Frame
5. Loosely secure the outer holes of the front bow
to the second holes of the rear bow using 2 bolts
(1/4 x 5/8 inch) and locknuts (
Figure 2 ).
Note:
Ensure that the ends of the front bow are
on the outside of the rear bow.
g309689
Figure 2
1. Bolt (1/4 x 5/8 inch) 4. Top bow
2. Locknut 5. Front bow
3. Rear bow
6. Loosely secure the top bow to the front and rear
bow using 2 bolts (1/4 x 5/8 inch) and locknuts
(
Figure 2 ).
7. Angle the top bow approximately 10 cm (4
inches) forward of vertical and tighten the
fasteners.
8. Loosely secure the braces to the posts using 2
bolts (1/4 x 1-1/4 inches), washers, and locknuts
(
Figure 3 ).
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3436-462* B