Toro 137-9769, Installation Instructions Manual

Page: 4 / 8

4
Applying the Decal
Parts needed for this procedure:
1 Decal 117-0346
Procedure
If decal 117-0346 is applied to the right post of the
roll bar on your machine and the support bracket now
covers that decal, apply the new decal to the inner,
lower side of the right post of the roll bar (
Figure 4 ).
Note:
If decal 117-0346 is not applied to the right
post of the roll bar on your machine, discard the decal.
g249924
Figure 4
1. Apply the new decal here. 2. Existing, covered decal
5
Securing the Upper
Trimmer Mount Assembly
to the Support Bracket
Parts needed for this procedure:
2 Carriage bolt (5/16 x 7/8 inch)
2 Flange nut (5/16 inch)
Procedure
Secure the upper trimmer mount assembly to the
support bracket using 2 carriage bolts (5/16 x 7/8 inch)
and 2 flange nuts (5/16 inch) as shown in
Figure 5 .
Note:
Multiple mounting hole locations are provided
to adjust the mounting position of the trimmer for
clearance.
g249811
Figure 5
1. Upper trimmer mount
assembly 3. Carriage bolt (5/16 x 7/8
inch)
2. Support bracket 4. Flange nut (5/16 inch)
4