manualshive.com logo in svg

Toro 137-5226, Installation Instructions, Page: 1 / 4

Share
Download
Toro 137-5226 Installation Instructions Download Page 1

Form No. 3415-957 Rev A

Mud Pump Transducer Relocation Kit

DD4045 Directional Drill

Model No. 137-5226

Installation Instructions

WARNING

CALIFORNIA

Proposition 65 Warning

This product contains a chemical or chemicals known to the State of California

to cause cancer, birth defects, or reproductive harm.

Preparing the Machine

1.

Move the machine to a level surface.

2.

Shut off the engine and remove the key.

3.

Set the battery-disconnect switch to the

OFF

position.

Installing the Kit

Loose Parts

5x

1x

1x

1x

1x

© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420

Register at www.Toro.com.

Original Instructions (EN)

Printed in the USA

All Rights Reserved

*3415-957* A

 

Summary of Contents for 137-5226

Page 1: ...of California to cause cancer birth defects or reproductive harm Preparing the Machine 1 Move the machine to a level surface 2 Shut off the engine and remove the key 3 Set the battery disconnect switch to the OFF position Installing the Kit Loose Parts 5x 1x 1x 1x 1x 2017 The Toro Company 8111 Lyndale Avenue South Bloomington MN 55420 Register at www Toro com Original Instructions EN Printed in th...

Page 2: ... Box A of Figure 2 3 Remove and save the transducer assembly and fitting currently installed Box A of Figure 2 4 Install the cap onto the port Box B of Figure 2 torque to 79 to 98 N m 58 to 72 ft lb 5 Connect the existing harnesses to the new wire harness Box C of Figure 2 Important Do not route the wire harness near moving parts 6 Secure the wire harness using a cable tie g215301 Figure 2 2 ...

Page 3: ...que the fitting to 301 to 336 N m 222 to 248 ft lb 4 Install the hose onto the tee fitting Box D of Figure 4 5 Install the fitting Box A of Figure 5 that was removed in step 2 shown in Box B of Figure 4 Torque the fitting to 301 to 336 N m 222 to 248 ft lb g213032 Figure 5 6 Install the reducer and O rings Box B of Figure 5 torque the reducer to 301 to 336 N m 222 to 248 ft lb 7 Install the transd...

Page 4: ...o 46 to 57 N m 34 to 42 ft lb 9 Route the harness along the existing harnesses over to the transducer Figure 6 Important Do not route the wire harness near moving parts g212417 Figure 6 10 Secure the harness using the cable ties Figure 7 g215300 Figure 7 Overview of the wire harness 4 ...

Reviews:

No comments