Toro 132-4193, Installation Instructions Manual

Page: 14 / 16

Figure 32
2. Weld the plate flag to the carriage assembly 5 7/8
inches away from the spindle end of the carriage
assembly as shown in
Figure 33 .
Figure 33
1. 5 7/8-inch gap 2. Plate flag
3. Paint the welded area.
4. Disconnect the wiring harness on the existing rear
sensor (
Figure 34 ) and route the wiring harness through
the holes on the bracket as shown in Figure 35 .
Figure 34
Current routing
Figure 35
Existing rear sensor
1. Existing sensor
5. Tag the sensor and wiring harness to note which part
of the harness goes to which sensor (
Figure 36 ).
6. Disconnect the wiring harness from the 2 proximity
switches (
Figure 36 ).
Figure 36
1. Pipe-breakout sensor 2. Pipe-return sensor
14