Form No. 3395-893 Rev A
Elevator Pressure Relief and Console Wire Harness
Protection Kit
2024 Directional Drill
Model No. 132-4162
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Qty.
Use
Guard plate
1
Bolts (M10)
2
U-nut
2
Install the wiring harness guard.
Valve
1
Straight fitting
2
Valve bracket
1
Bolt (M6)
2
Flange nut
2
Install the valve and bracket.
Large tee fitting
1
Small tee fitting
1
Long hydraulic hose
1
Short hydraulic hose
1
Install the fittings and route the hydraulic hoses.
Installing the Wiring Harness
Guard
1.
Move the machine to a level surface, turn off the
machine, and remove the key.
Note:
Swing the operator platform full-out for easier
access; refer to the machine
Operator’s Manual
.
2.
Using the guard plate as a guide, drill a hole into the
frame; refer to
.
Note:
Be careful not to drill into the wiring harness
wires.
Figure 1
1.
Guard plate
3.
Bolt (M10)
2.
U-nut
4.
Drill the hole here.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3395-893* A
