5
Installing the Hydraulic Hoses
for the Boom-Lift Cylinders
Parts needed for this procedure:
1
Male quick-connect coupler
1
Female quick-connect coupler
1
Hydraulic hose (3/8 x 61 inches)
1
Hydraulic hose (3/8 x 79 inches)
2
Cable tie
2
Tube-clamp half
1
Flange-head bolt (5/16 x 1-1/2 inches)
Assembling the Quick-Disconnect
Fittings to the Hoses
Note:
Ensure that the tank skid is raised and that the
cylinder lock is in place.
Note:
Ensure that the center boom section is installed; refer
to the
Installation Instructions
for the sprayer.
1.
Assemble the male quick-connect coupler onto the
male hose fitting (
) of the hydraulic hose (3/8
x 79 inches).
Figure 10
1.
Hydraulic hose (3/8 x 79
inches)
4.
Female quick-connect
coupler
2.
Hydraulic hose (3/8 x 61
inches)
5.
Male quick-connect
coupler
3.
Male hose fitting
2.
Assemble the female quick-connect coupler onto the
male hose fitting (
) of the hydraulic hose (3/8
x 61 inches).
3.
Torque the quick disconnect fitting and the hose to 24
to 30 N∙m (18 to 22 ft-lb)
Routing the Hydraulic Hoses
1.
At the boom-lift manifold, note the tank hydraulic hose
at port-T and the pressure hydraulic hose at port-P of
the manifold (
).
Figure 11
1.
Boom-lift manifold
3.
Hydraulic hose—pressure
(port-P fitting)
2.
Hydraulic hose—tank
(port-T fitting)
4.
Front of the machine
2.
Route the hydraulic hose (3/8 x 79 inches) and the
hydraulic hose (3/8 x 61 inches) along the left frame
channel of the machine as shown in
Note:
You will secure the hoses in later a later step.
6
