Description
Qty.
Use
Washer-fluid tank
1
Tank-support bracket (216 x 95 mm (8-1/2 x
3-3/4) with 90° flange)
1
Carriage bolt (5/16 x 3/4 inch)
2
Flanged locknut (5/16 inch)
2
Hose (3/16 inch)
1
Barbed hose connector
1
Wire harness
1
Push fastener
3
Cable tie
1
Install the windshield washer fluid kit (MD-series models).
Preparing the Machine
1.
Park the machine on a level surface and set the parking
brake.
2.
Raise the hood; refer to your
Operator’s Manual
.
3.
Raise the cargo box; refer to your
Operator’s Manual
.
4.
Shut off the engine and remove the key.
5.
Disconnect the negative-battery cable; refer to your
Operator’s Manual
.
Installing the Windshield
Washer Fluid Kit
For GTX-Series Models
Installing the Washer-Fluid Tank
For Machines with the Storage Box Kit Installed
If you have the Storage Box Kit installed, discard the
washer-fluid-tank bracket.
1.
Install the washer-fluid tank to the storage box with the
4 carriage bolts (5/16 x 3/4 inch) and 4 flange nuts
(5/16 inch) as shown in
Figure 1
1.
Storage box
3.
Flange nut (5/16 inch)
2.
Carriage bolt (5/16 x 3/4
inch)
4.
Washer-fluid tank
2.
Torque the flange nuts to 1,987 to 2,542 N∙cm (175
to 225 in-lb).
2