Form No. 3379-511 Rev A
Reel Bearing and Seal Rebuild Kit
2011 and Before 11 or 14–Blade Cutting Unit for Greensmaster
®
Flex
™
Mower
Model No. 130-0105
Installation Instructions
Installation
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
1
Preparing the Machine
No Parts Required
For All Models
1.
Position the mower on a flat, level work surface. Make
sure the engine is Off. Remove the spark plug wire
from the spark plug.
2.
Separate the cutting unit from the traction unit; refer to
your
Operator’s Manual
for the procedure.
Note:
If a grooming reel kit is installed to the
cutting unit, remove the grooming reel; refer to your
Grooming Reel
Operator’s Manual
for the procedure.
3.
Remove the bedbar from the cutting unit; refer to your
Operator’s Manual
for the removal procedure.
4.
Remove the belt cover and the reel drive belt from
the left side of the cutting unit; refer to your
Operator’s
Manual
for the procedure.
5.
Block the reel with a piece of wood to prevent it from
turning. Remove the flange nut securing the drive
pulley to the reel shaft (Figure 2 and Figure 3). Remove
the pulley from the shaft. Remove the woodruff key
and the spacer from the reel shaft.
6.
Loosen and remove the 2 locknuts, capscrews, and
lockwashers securing the reel drive plate assembly to
the left side of the cutting unit (Figure 1). Remove
the assembly from cutting unit sideplate. Remove the
spacer (if equipped) from behind the reel drive plate.
Figure 1
1.
Spacer
4.
Reel drive plate assembly
2.
Locknut, capscrew, and
lockwasher
5.
Reel drive belt
3.
Reel drive pulley
7.
Remove the front roller; refer to your
Operator’s Manual
for the removal procedure.
For Models with Integrated Bearing
Housings
1.
Loosen the screws securing the rear roller.
2.
Remove the 2 screws, washers, and locknuts securing
the counterweight to the right end of the cutting unit
(Figure 2).
3.
Remove the reel bearing lock nut from the right side
of the reel (Figure 2).
Note:
The reel bearing lock nut has left hand threads.
4.
Remove the side plates from the frame and reel; refer
to your
Operator’s Manual
. Remove the reel.
5.
Remove and discard both the oil seals from each
bearing housing (Figure 2).
6.
Remove and discard the bearing from the left hand
side plate.
7.
Remove and discard the retaining rings, bearing, wave
washer, and thrust washer from the right hand side
plate.
8.
Clean the bearing housings.
© 2013—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3379-511* A
