Page 1: ... of California to cause cancer birth defects or reproductive harm 1 Preparing the Machine No Parts Required Procedure 1 Lock the handle in the vertical position Figure 1 refer to Adjusting the Handle Height in the Operator s Manual 1 G016519 Figure 1 1 Handle locked in the vertical position 2 Tip the machine onto its side with the dipstick down until the upper handle rests on the ground WARNING Th...
Page 2: ...re 2 2 Remove each blade as shown in Figure 3 G016530 1 2 3 4 Figure 3 1 Spindle 2 3 Blade 2 2 Blade driver 2 4 Blade bolt 2 3 Installing the Baffle No Parts Required Procedure 1 Remove the 4 bolts and 4 nuts in the front of the machine housing Figure 4 Figure 4 1 Bolt 4 3 Nut 4 2 Baffle 2 Install the baffle with the 4 bolts and 4 nuts that you removed in step 1 Figure 4 2 ...
Page 3: ...e bolt to 60 ft lb 82 N m Important A bolt torqued to 60 ft lb 82 N m is very tight Put your weight behind the wrench and tighten the bolt securely This bolt is very difficult to overtighten g016537 Figure 5 3 Rotate the installed blade 1 4 turn until it is vertical and install the other blade in the same manner as the first refer to step 1 Note The blades should be perpendicular forming an invert...
Page 4: ......
