Fuel System
Maintenance
Inspecting Fuel Lines and
Connections
Check the fuel lines and connections every 400 operating
hours or yearly, whichever occurs first. Inspect them for
deterioration, damage, or loose connections.
Replacing the Fuel Filter
Replace the fuel filter every 800 operating hours or
yearly, whichever occurs first.
1. Raise the box and support it with the prop rod.
2. Place a clean container under the fuel filter.
3. Remove the clamps securing the fuel filter to the fuel
lines (Figure 37), as follows:
A. Squeeze the clamp tabs together and slide the
clamps up the hose off of the filter hose fittings.
B. Pull the hose ends off of the filter hose fittings.
Figure 37
1.
Fuel filter
4. Install the replacement filter to the fuel lines with the
clamps previously removed.
Mount the filter so that the arrow points
toward
the
carburetor.
Electrical System
Maintenance
Replacing the Fuses
There are 3 fuses in the electrical system. They are
located beneath the bed in a box on the right hand side
of the frame (Figure 38).
Charge circuit
25 amp.
Lights
10 amp.
Power Point
10 amp. (15 amp. max.)
Low oil light and hour meter
10 amp.
G002190
Figure 38
1.
Charge circuit
3.
Power point
2.
Lights
4.
Low oil light and hour
meter
Replacing the Headlights
Specification: GE #862
1. Set the parking brake, turn the ignition off, and
remove the key.
2. Switch the headlights off.
3. Reach beneath the dash and rotate the lamp assembly
1/4 turn counterclockwise (Figure 39).
31
