Form No. 3355-330 Rev A
Washout Port Kit
Model No. 112-5803
Installation Instructions
Removing the Bolt from the
Mower Housing
No Parts Required
Procedure
1. Shut off the engine and wait for all moving
parts to stop.
2. Disconnect the wire from the spark plug.
If you leave the wire on the spark plug,
someone could accidently start the
engine and injure you or bystanders.
Disconnect the wire from the spark plug
before you perform any maintenance.
Also, move the wire away so that it does
not accidentally contact the spark plug.
3. Clean the underside of the mower housing and
examine it for damage or excessive wear.
A corroded or cracked mower housing
may be further weakened by installing
the washout port, causing the mower
housing to crack and break, exposing
you or others to thrown objects and to
the running blade.
•
Install the washout port only on a
sound mower housing.
•
Replace a worn, cracked, or damaged
mower housing immediately.
•
Never put your hands or feet under or
through the openings in the mower
housing.
4. Remove the large bolt and nut from the mower
housing.
Installing the Washout Port
Parts needed for this step:
1
Washout port
2
Bolt
2
Washer
2
Locknut
Procedure
1. Secure the washout port to a garden hose.
2. Insert the washout port (attached to the garden
hose) into the hole in mower housing where
you removed the large bolt and move the
washing port and garden hose to the preferred
location.
Note:
The hose should not interfere with the
wheels, handles, or controls.
3. Use the washout port as a template to mark
the location of the two holes in the mower
housing for the fasteners.
4. Center punch and drill the two holes (9/32-inch
diameter) that you marked in step 3.
5. Install the washout port on the mower facing
outward, and secure it with the bolts and
locknuts provided in the kit (Figure 1).
G003843
1
2
3
4
5
Figure 1
1. Bolt (2)
4. Garden hose
2. Washer (2)
5. Locknut (2)
3. Washout port
© 2006—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA.
All Rights Reserved