Toro 106-2643, Installation Instructions

Page: 1 / 2

Form No. 3421-593 Rev A
Groomer Pull Link Kit
for Serial Number 401499999 and Before Greensmaster ® 3120 or
3150 Series Traction Units
Model No. 106-2643
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California
to cause cancer, birth defects, or reproductive harm.
Determine the left and right sides of the machine from
the normal operating position.
1. Park the machine on a level surface, lower the
cutting units, shut off the engine, set the parking
brake, remove the ignition key, and disconnect
the spark plug.
2. Remove the roller, spring washers, pull link
assemblies, flat washers, lockwashers, and
grease screws from the pull frame (
Figure 1 ).
g245908
Figure 1
1. Roller 6. Lock washer
2. Spring washer 7. Grease screw
3. Pull link assembly 8. Jam nut
4. Pull frame 9. Ball joint receiver
5. Flat washer
3. Remove and retain the ball joint receivers from
the pull link assemblies (
Figure 1 ). Discard all
of the previously removed hardware except the
roller and ball joint receivers.
4. If the pull frame does not have 2 holes in the
underside, drill them at the location shown in
Figure 2 using a 0.221 inch drill bit.
g245919
Figure 2
1. 49.4 cm (19-7/16 inches) 3. 1.9 cm (3/4 inch)
2. 8.8 cm (3-1/2 inches)
5. Secure 2 bumpers to the underside of the pull
frame using 2 self tapping screws (
Figure 3 ).
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3421-593* A