Toro 106-2643, Installation Instructions

Page: 2 / 2

g245920
Figure 3
1. Bumper 2. Self tapping screw
6. Slide a frame spacer onto each end of the roller
(
Figure 4 ).
g245921
Figure 4
1. Roller 6. Pull link assembly
2. Frame spacer 7. Flange bushing
3. Pull frame 8. Grease screw
4. Flat washer 9. Jam nut
5. Pull link spacer 10. Ball joint receiver
7. Secure the roller to the pull frame as shown in
Figure 4 .
8. Thread a jam nut and the previously removed
ball joint receiver onto the pull link assembly
( Figure 4 ). Do not tighten the jam nut at this
time.
9. Adjust the ball joint receiver so that the distance
between the grease screw and the opening in
the ball joint receiver is 9.1 cm (3.6 inches) and
tighten the jam nut to secure it in place (
Figure
5 ).
g245942
Figure 5
1. 9.1 cm (3.6 inches)
10. Thread a ball stud onto each end of the groomer
front rollers (
Figure 6 ).
g245963
Figure 6
11. Slide the sleeve on the ball joint receivers back
and hook them onto the groomer ball studs.
2