Toro 09960, Operator'S Manual, Page: 36 / 92

Calibrating the Tine Ground
Height
Service Interval: Before each use or daily
Important:
Calibrate the tine ground height each
time you change tines or replace worn tines.
Preparing the Machine
1. Ensure that the coring head is raised.
2. Park the machine on a level surface, fully raise
and latch the handlebar to engage the parking
brake, shut off the engine, remove the key, and
wait for all moving parts to stop.
3. Remove the coring-head cover; refer to
Removing the Coring-Head Cover (page 68) .
4. Rotate coring-head pulley ( Figure 62 ) until the
outermost tines are aligned closest to the ground
(
Figure 63 ).
Important:
Keep your fingers away of the
area where the belt merges and departs the
pulley so that you do not pinch your fingers.
g343368
Figure 62
g343367
Figure 63
1. Outermost tines (closest to the ground)
5. Install the coring-head cover; refer to Installing
the Coring-Head Cover (page 69) .
Running the Teach Ground Height
Application
1. Rotate the ignition key to the R
UN
position.
Note:
The T
RANSPORT
mode screen or the
A
ERATE
mode screen displays ( Figure 64 ).
g358601
Figure 64
2. Move the handlebar so that you can see the
outermost tines you positioned in
Preparing the
Machine (page 36) .
3. Press the right InfoCenter button until the T
EACH
G
ROUND
H
EIGHT
wizard displays.
4. On the Teach Ground Height screen ( Figure 65 ),
press the center InfoCenter button.
36