Toro 07390 Workman HDX-Auto, Service Manual, Page: 177 / 280

Workman HDX Auto Page 6 − 29 Electrical System
Windshield Washer/Wiper Switch (Machines with Operator Cab)
The windshield washer/wiper switch controls the opera-
tion of the windshield wiper and washer pump. The
switch is located in the roof console (Fig. 41).
Testing
1. Park the machine on a level surface, lower the cutting
deck, set the parking brake, and shut off the engine.
2. To access the switch, do as follows:
A. Remove the 10 clips, 10 sealing washers, and 10
flange − head screws that secure the roof to the cab
frame, and remove the roof.
B. Remove the console foam.
C. Remove the console panel from the roof console.
3. Disconnect the wire harness electrical connector
from the windshield wiper/washer switch.
4. With the use of a multimeter (ohms setting), test the
switch functions to determine if continuity exists be-
tween the various terminals for each switch position.
Check the continuity between the switch terminals. The
windshield wiper/washer switch terminals are identified
in Figure 42 and the circuitry of the switch is shown in be-
low table:
SWITCH
POSITION
NORMAL
CIRCUITS
OTHER
CIRCUITS
OFF 2 + 1 None
WIPER ON 2 + 3 None
WASHER ON 2 + 3 5 + 6
5. Replace the windshield wiper/washer switch if test-
ing determines that the switch is damaged.
6. If the windshield wiper/washer switch testing is cor-
rect and a circuit problem still exists, check the wire har-
ness; refer to the Chapter 9 − Electrical Drawings.
1. Washer/wiper switch 2. Console panel
Figure 41
1
2
Figure 42
7. After you complete the testing, connect the wire har-
ness connector to the windshield wiper/washer switch.
8. Position the console foam. Secure the roof to the cab
frame with the 10 clips, 10 sealing washers, and 10
flange − head screws.
Electrical System