Toro 07385TC Workman HDX-D, Original Instructions Manual

Page: 56 / 64

g002376
Figure 64
1. Dipstick
5. Unscrew the dipstick from the top of the
transaxle and wipe it with a clean rag.
6. Screw the dipstick into the transaxle and ensure
that it is fully seated.
7. Unscrew the dipstick and check the fluid level.
Note:
The fluid should be up to top of the flat
portion of the dipstick.
8. If the level is low, add enough of the specified
fluid to achieve the proper level.
Checking the High-Flow
Hydraulic-Fluid Level
TC Models Only
Service Interval: Before each use or daily—Check
the high-flow hydraulic-fluid level
(TC models only). (Check the level
of hydraulic fluid before the engine
is first started, and daily thereafter)
Hydraulic-fluid type: Toro Premium All Season
Hydraulic Fluid
(Available in 5-gallon pails or
55-gallon drums. Refer to the parts catalog or Toro
distributor for part numbers.)
Alternate fluids: If the Toro fluid is not available,
another conventional petroleum-based fluid may
be used provided it meets the following material
properties and industry specifications. Consult with
your lubricant distributor to identify a satisfactory
product.
Note:
Toro does not assume responsibility for
damage caused by improper substitutions, so use
only products from reputable manufacturers who
stand behind their recommendation.
High Viscosity Index/Low Pour Point Antiwear
Hydraulic Fluid, ISO VG 46
Material Properties:
•
Viscosity—ASTM D445 cSt @ 40ºC: 44 to 48/cSt
@ 100ºC: 7.9 to 8.5
•
Viscosity index, ASTM D2270—140 to 152
•
Pour point, ASTM D97— -35ºF to -46ºF
•
FZG, fail stage—11 or better
•
Water content (new fluid)—500 ppm (maximum)
Industry Specifications: Vickers I-286-S, Vickers
M-2950-S, Denison HF-0, Vickers 35 VQ 25 (Eaton
ATS373-C)
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Clean the area around the filler neck and the
cap of the hydraulic tank (
Figure 65 ).
5. Remove the cap from the filler neck.
g010324
Figure 65
1. Cap
6. Remove the dipstick ( Figure 65 ) from the filler
neck and wipe it with a clean rag.
7. Insert the dipstick into the filler neck, then
remove it and check the fluid level.
Note:
The fluid level should be between the 2
marks on the dipstick.
8. If the level is low, add the appropriate fluid
to raise the level to the upper mark; refer to
Changing the High-Flow Hydraulic Fluid and
Filter (page 58)
.
9. Install the dipstick and cap onto the filler neck.
10. Start the engine and turn on the attachment.
Note:
Let them run for about 2 minutes to purge
air from the system.
Important:
The machine must be running
before starting the high-flow hydraulics.
56